Результаты проверки
После проведения поверки, результаты сравниваются с эталонными значениями температуры. Это позволяет определить погрешность измерения и, при необходимости, скорректировать показания. Полученные записи температуры сертифицированных приборов могут быть использованы для составления официальной документации.
Поверочные приборы
Два пирометра, RGK PL-12 и RGK PL-8, проходили поверку в соответствии с методикой МП РТ 2049-2014. Первый – бесконтактный термоизмеритель высокой точности, второй – универсальный инфракрасный термометр.
Частота поверки
Частота поверки пирометров зависит от их класса точности, условий эксплуатации и требований стандарта. В некоторых случаях требуется ежегодная поверка, в других – раз в два-три года.
Польза от поверки
Поверка пирометров обеспечивает точность измерений и надежность работы прибора. Точные данные о температуре критически важны для контроля процессов производства и качества продукции.
Проведение процедуры
Для сдачи пирометра в поверку необходимо обратиться в аккредитованную лабораторию или центр поверки. Прибор должен быть чистым, исправным и снабжен документацией о его эксплуатации и предыдущих поверочных процедурах.
Сроки поверки
Сроки поверки пирометров могут варьироваться в зависимости от класса точности и условий эксплуатации. Некоторым приборам требуется поверка ежегодно, другим – раз в два-три года. Если есть аномалии в работе устройства или после ремонта, также рекомендуется провести поверку.
Deadlines and Frequency of Pyrometer Verification
The deadlines for verification are determined by the requirements of standards and regulatory documents, as well as the characteristics of a specific pyrometer and the conditions of its use.
However, in general, it is recommended to carry out the verification procedure at least once a year. In some cases, especially when using pyrometers in critical processes or in conditions of increased pollution, more frequent verification is recommended – once every six months.
Pyrometer verification is an important procedure to ensure measurement accuracy and the reliability of the device. The appropriate procedure allows for monitoring and maintaining the quality of production processes and products. The Metrology service of A3 Engineering is accredited and carries out verification of various equipment to ensure high measurement accuracy and reliable operation.
Features and Types of Pyrometer Verification
Pyrometer verification has its own features that need to be taken into account when conducting it.
Firstly, it is necessary to use high-precision standards capable of ensuring the required measurement accuracy.
Secondly, strict adherence to the procedure and processing of the obtained data for further correction of readings.
The methodology may seem like a simple process, but in reality, it is quite complex. The necessary elements for the successful completion of the process include:
- High-precision calibration standards
- Adherence to verification procedure
- Data processing for correction of readings
There are different types of pyrometer verification:
- Primary verification
- Periodic verification
- Acceptance verification
The procedure is carried out by special organizations accredited to perform this work. The results are documented in the corresponding protocol, which is the basis for decision-making on the further use of the device.
Accreditation Certificate
Verification and calibration are carried out in our own accredited laboratory. Therefore, all procedures are carried out quickly and at a lower cost. Our company has all the necessary equipment for verification and calibration of even technically complex measuring instruments.
